Related Articles
BOWLINE
The bowline (pronounced "bo-lin") is rightfully known as the king of knots. It is easy to tie and untie, increases its grip as tension is applied, and will never jam. It takes times and practice to learn, but the effort will be well rewarded. Use the bowline for attaching jibsheets and halyards to sails.
1. With your palm down, hold the working end between your fore- and index fingers, placing it over the standing part with your thumb. 2. Twist your wrist so your palm faces up and a loop has been formed in the line. 3. Pass the working end behind the standing part and then back through the loop. Remember, after the end passes under one part it must then pass over the next. Always alternating. 4. Before putting into service, snug the parts up to make sure they are set.
SHEET BEND
A bend joins two ropes. The worst way of doing this is with a square knot, which can slip or come apart. The best way is with the sheet bend. It is easy to tie, strong, secure, and works well with ropes of dissimilar sizes. If you are going to remember one bend, this is it.
1. Make a loop in the end of one rope. If one line is heavier than the other, make the loop in it. Pass the end of the other rope through and around the loop as shown. 2. The working end should exit the knot on the same side as the loop's short-ended side. 3. You may have noticed that the sheet bend is similar in construction to the bowline, so it can be tied in the same manner.
