Header - Ads / PCD

replace ignition switch

Answers

answers (2)
Kevin Falvey's picture

recornelius

Ok. Easy Pie.

1 Pull the old one, take it to marine supply.

2.Buy a new one with same amount of terminals on back, and, if yours is so equipped, the "push-to-choke" function.

3. You might want to make a little drawing of the which wire goes to what terminal while you are removing the old one.

G'Luck
Kevin

Bonediver's picture

Think its best to look at switch, count terminals, then go buy switch. Replace ONE wire at a time, make sure power is OFF or disconnect batt.

Post Your Answer

All submitted answers are subject to the rules set forth in our Privacy Policy and Terms of Use