Bad fuel is the death knell for a boat, because it will gum up the system, choke off the engine and leave you looking for a tow home. Even so-called “clean” fuel can cause fits with a fuel system thanks to its ethanol content. The solution? Running the fuel through a water-separating fuel filter. Many new outboard and inboard boats come with a remote filter pre-installed in the fuel system. But some new, and many older, boats don’t. No worries: You can order a kit from West Marine or other supply store and install it yourself over the weekend.
First, you’ll need the proper kit. For outboards, that’ll generally mean a filter equipped with a clear plastic collection bowl. For inboards, use a filter fitted with an aluminum bowl for gas, or a clear glass or plastic inspection bowl for diesel. A disposable filter without a collection bowl can also be used.
Open hatches to ensure ventilation. Close the fuel valve at the tank and cut the supply hose at the mounting location, and then drain the contents. Or, plug the line by inserting a bolt and securing with a hose clamp.
Install the head unit vertically, above bilgewater, between the tank and engine (or primer bulb if on an outboard). The hoses should reach the engine and tank without kinking or making sharp turns. Drill pilot holes in the mounting point, inject sealant and fasten with self-tapping stainless steel screws. If mounting to the hullside, epoxy-glue a painted piece of plywood in place as a mounting plate. Drill, seal and screw as above.
Install the filter’s fuel fittings using thread sealant, and smear some motor oil on the gaskets or O-rings for the element and the inspection bowl.
Attach the hose from the tank to the “in” port and from engine to the “out” port. Double-clamp firmly but don’t pinch the rubber hoses. If extra hose is needed, use U. S. Coast Guardapproved Type A1-15 of the same diameter as the hose it’s replacing.
Start the engine. Check for leaks at a fast idle, and then sea-trial the system close to home at high rpm, watching closely for leaks all the while.
The ABCs of Filter Kits
Most manufacturers recommend a 10-micron “spin-on” filter to best deal with E10 fuel. Working through your engine manufacturer will help to match the proper filter to the fuel system, or you can buy a filter kit from reputable manufacturers such as Racor, Sierra, Moeller, Mallory or Tempo. These kits generally include the filter element, a collection bowl (clear plastic for outboards, aluminum for inboards) and a mounting bracket or head unit made of aluminum or stainless steel. Some kits may include the brass or stainless steel threaded fittings for the hose barb.